DIY Ridiculously Over-Sized Pendant Necklace

It was a little traumatizing to finally get to Topshop — after hearing about it for years — and then find not much age-appropriate for me, other than a bangle. So let’s look at the positive in this situation. What a bangle it is!

Super Big Whoop Pendant Necklace

But here’s the thing: I never saw it as a bangle. It was destined from first sight to become a big-whoop pendant necklace.

The key is, have a fresh eye when looking at things. Don’t use things as they’re intended. Bangles are perfect for making over-sized pendants.

You can make a similar necklace with any over-sized item with a big opening in the middle. Then find something to hang in the opening. Here you’ll see what I mean …

Necklace Assembly

The supplies are somewhat simple. I say “somewhat” because usually my DIYs do not involve plugging something into an electrical outlet. If an electrical plug is involved, that means there’s some drilling or sawing or heavier-duty sanding, and it’s not so super simple any more.


Supplies to Make Super Oversized Pendant Necklace

Inspection Time

Everything passed inspection. And believe me you don’t want to disappoint this particular Inspector because you will hear about it for awhile. Maybe even at 4 a.m.

Making the Pendant Necklace

This bangle is wood with a thin metal lining. As a first step, I drilled a hole. The drill bit was able to drill through the thin metal but the pressure distorted the metal a bit. The wood also split, but paint or wood stain can hide that. I started with the smallest drill bit and gradually stepped up, but the wood still split. So, be careful. These things are manufactured cheap.

Drilling the Bangle

Be Careful Drilling Wooden Bangles

Safety tip: Watch out for sharp metal pieces. Sand them down and vacuum up the metal shards ASAP. Especially if you have kids and four-legged Inspectors running around.

Clean Up Sharp Metal Shards

I had two matching gold-tone pendants (probably from JoAnn or Michaels jewelry-making aisles) already on hand. So I glued them together with E6000 glue, because the pendant is free to spin and I wanted both sides to look the same.

E6000 Glue is Awesome

DIY Pendant Necklace

Then, I knotted leather cord on the gold-tone pendants. Then threaded this leather cord through the hole drilled in the bangle. This was tough – the leather was thin enough to go through the hole but it needed help getting pulled through.

Help Needed

Here’s a trick:

Poke a needle or pin through the leather cord, and pull the needle or pin through the hole. The leather cord will follow.

Try to use a strong needle or pin because I broke a few thin needles while trying to poke them through the leather. It was tough stuff.

Leather Cord Threading Tip

Leather Cord Threading Tip

To finish off the necklace, I simply knotted the leather cord. It’s a long necklace so it doesn’t need a fixture. You can just slip the necklace on over your head.

Here’s the obligatory pin-worthy image:

DIY Ridiculously Over-Sized Pendant Necklace

That’s really it! Super easy.

If you find an object you’d like to use as a pendant that can’t be drilled, such as a thin metal bangle, you can creatively knot the cord around it instead of drilling through it.


Did you like this post? Don't miss out on more:

What topics interest you?